American Standard Repair Kit - DIY Bath Tub & Shower

Showing reviews 1-10 of 12 | Next

1. Color Matched Perfectly

   Posted by Harold Poyner on 3rd Sep 2019

   Easy to use product. Used it as a finish coat on a crack repair. Color matched perfectly without having to add toners.

   ---

2. American Standard repair kit

   Posted by Unknown on 15th Jul 2019

   Hardner was defective, Waited 3 days. Used more than the directions recommended but still had to remove product and wait for more hardner. The company was very helpful and sent what I needed.

   ---

3. Great product...saved my project

   Posted by Craig Calandrelli on 19th Dec 2017

   I installed a new direct to stud surround on an okd tub. I didnt support a lowrr corner and after completing thd drywall I leaned on it and cracked the acrylic. I used a Dremel to v-out the crack and drill a small hole. Used expanding fill to support the area behind. I taped off the crack and used the putty. The tape helped keep the application under control since I am a sloppy worker. After removing the taps and heating to dry, I sanded and the results were perfect. Super smooth finish. The color was slightly off because I got over zealous with the dye...but you can hardly see it. Great product.

   ---

4. Worth Every Penny

   Posted by Unknown on 16th Nov 2017

   I had a quarter sized chip in a light gray bathtub. The only contractor I could find wanted to refinish the entire tub to "get the color to match" right. I decided to try this repair kit and was very pleasantly surprised. The color matched perfectly, and after following the repair directions, I was able to make a totally invisible repair. It takes a bit of finesse on the sandpaper and rubbing compound, but if you're patient, it's achievable. VOC's are a bit nasty, so pay attention to adequate ventilation.

   ---

5. This product worked great!

   Posted by Unknown on 16th Aug 2016

   A handyman had attempted to touch-up my bathtub with a similar product, but the touch-up job was terrible - no match whatsoever to the tub color. So, I had my doubts about whether this would work or not. It took every available drop of the white tint with a small amt of the main product to match the tub color, so I was able to match it perfectly. Using it, to redo the handyman's work, you can't tell anything was ever done to the tub! The product exceeded my expectations! Thank you.

   ---

6. Whirlpool tub repair

   Posted by Leon on 6th Jan 2016

   The tile man dropped a tile in the tub and said it was like that!!! Right!!! So I went on-line to purchase the repair kit for American Standard fiberglass tub finishes. It was an exact match the first time and made the repair in no time flat!! Applied the product a little heavy and smooth it out with a rag and acetone, gently. All is good!!!

   ---

7. Great Product

   Posted by Elaine on 17th Sep 2015

   We just install our tub and we notice a small nick in it to the fiberglass. Applied the product as directed and its like new. Matched exactly to american standard arctic white tub we have.

   ---

8. IT Worked!

   Posted by Richard on 4th Jul 2015

   Followed the instructions and waited for it to dry, took four hour but the house was at 71 degrees. Sanded as directed the polished can't tell there was any blemish. Small gouge.
   
   Note from Surface-Repair.com
   Colder weather and the tub being cold from the night will slow down the cure.
   Speed up the cure with double the drops of catalyst and apply heat around the repair with a hair blow dryer until the surface is warm.

   ---

9. Thank goodness for this product

   Posted by Unknown on 23rd Nov 2014

   We were remodeling our bathroom. The plumber accidently spilled some glue on the tub base and it left a 2 inch hole. We did not want to replace the whole tub. Thanks to this product we didn't have to! It worked perfectly!

   ---

10. Product worked well

    Posted by Unknown on 28th Jan 2014

    Good product

    ---

Showing reviews 1-10 of 12 | Next